Download MTD E600E Operator`s manual
Transcript
It is not recommended that you operate this snow thrower on gravel as loose gravel can be easily picked up and thrown by the auger causing an injury or damage to the snow thrower. TirePressure (Pneumatic Tires) The tires are over-inflated for shipping purposes. Check tire pressure and reduce to 15 to 20 psi. NOTE: If the tire pressure is not equal in both tires, Carriagd Bolts kid .......... the unit may pull to one side or the other. __,_Shoes Figure 11 SECTION4: KNOWYOURSNOWTHROWER WARNING: Be familiar with all controls and their proper operation. Know how to stop the machine and disengage them quickly. Operating Controls Auger Control Traction / Auger Control Lock Shift Lever The shift lever is located in the center of the handle panel. The shift lever may be moved into one of eight positions. Run engine with throttle in the fast position. Use the shift lever to determine ground speed. See Figure 12. Forward - There are six speeds. Position number one (1) is the slowest. Position number six (6) is the fastest. Reverse - There are two reverse (R) speeds R1 and R2. The "R2" closest to the operator (ait the way back) is the faster of the two. AugerControl The auger control is located on the left handle. Squeeze the control to engage the augers. Release to stop the snow throwing action. (Traction control must also be released.) See Figure 12. Traction/ AugerControlLock The traction control is located on the right handle. Squeeze the control to engage the wheel drive. Release to stop. Directional Control • AUGERCONTROL 61 4g 2Q F CHUTE OIR_CTIONAL 11 CONTROL R21m CLOC_SE TO D_SC_AR_ELEFT _OU_TERCLOCK_SE TO D_SC_RGE R_G_T Figure 12 This same control also locks the auger control so you can turn the chute directional control without interrupting the snow throwing process. If the auger control is engaged with the traction control engaged, the operator can release the auger control (on the left handle) and the augers will remain engaged. Release the traction control to stop both the augers and wheel drive (auger control must also be released). See Figure 12. Chute DirectionalControl The chute directional control is located on left hand side of the snow thrower. See Figure 12. To change the direction in which snow is thrown, turn chute directional control as follows: 10