Download Binatone e820 System User guide

Color profile: Generic CMYK printer profile
Composite Default screen
Customising your handset
General points
Auto-answer
You can customise the settings of your e820 handset,
using a menu which is shown on the handset’s display.
Please note that:
■
If you don’t press any button for about 25 seconds,
the handset will time out and the display will return
to standby mode.
■
When you confirm any setting you have made, you’ll
hear a confirmation tone. If you make a mistake,
you’ll hear a warning tone.
■
At the end of each set of steps, you can return the
handset to standby mode by either:
— replacing the handset on the base unit
— pressing and holding the HANG UP/C button
When a call comes in, you need to press any button to
answer it. Or you can set auto-answer — so, if the
handset is in place on the base unit, you simply lift it to
answer the call, without pressing any button.
1
Press the PROG button then 1 5
2
Use the ‡ or ˆ button to set:
0 for auto-answer off
1 for auto-answer on
3
Press the PHONE/OK button to confirm
35
E:\Binatone2004\e820\e820_UK_03.vp
15 November 2004 11:48:21