Download Sharp R-408H Specifications

SECTION A GENERAL INFORMATION A.1 PREFACE Magnatex 3575 Series ANSI Pump is a horizontal overhung, end suction and top discharge with an open impeller, which meets the requirements of ANSI B73.1, fabricated with the best materials and continuous inspection. With correct installation, periodic inspection, correct usage and careful maintenance, this pump will yield a long satisfactory service life. WARNING 9 Before performing pump maintenance always make sure power to the driver is locked out. 9 Consult either the pump manufacturer or an authorized dealer before changing the pump operation conditions from those under which it was sold. 9 Never operate the pump without its coupling guard installed. 9 Do not use heat to remove impeller or to disassemble the pump, trapped liquid may cause an explosion. 9 Do not operate the pump without proper safety devices installed. 9 Always make sure both the discharge valve and the suction valve are open before operating the pump. 9 Always prime the pump before starting. 9 Piping should not be forced to make connection with the pump. 9 When the system is pressurized, neither vent nor drain valves should be opened, nor should any plugs be removed. 9 Never operate below minimum recommended flow. ‐ 1 ‐