Download Sharp AR-M230 Series Specifications

CONVENIENT DIALLING METHODS
AUTO-DIALLING
This product includes an auto-dialling feature to make dialling easier. By programming frequently dialled numbers,
you can call and send documents to these locations by means of a simple dialling operation (p.16). There are two
types of auto-dialling: rapid dialling and group dialling. To program auto-dial numbers, refer to pages p.68, p.72.
Rapid dialling
Group dialling
Simply press a rapid key and then press the [START]
key ( ) to dial the programmed location. When using
F-code transmission, a sub-address and passcode
can also be programmed (p.52).
Multiple destinations can be programmed into a single
rapid key. This is convenient for successively sending
a document to multiple locations.
• The destinations can be stored by specifying rapid
keys, or by directly entering full fax numbers with the
numeric keys (the destinations do not need to be
previously stored in rapid keys).
No.001:SHARP CORPORATION
0666211221
SHARP CORPORATION
No.005:SHARP GROUP
GROUP :025
CORPO. TPS
SHARP CORPORATION
SHARP GROUP
FREQUENT USE
CORPO. TPS
SHARP GROUP
ABCD
EFGHI
JKLMN
OPQR
Touch the [ADDRESS BOOK] key in the initial screen
to display the above screen.
FREQUENT USE
ABCD
EFGHI
JKLMN
OPQR
Touch the [ADDRESS BOOK] key in the initial screen
to display the above screen.
Note
• A total of 500 rapid dial and group dial keys can be programmed. (p.66)
• Programmed rapid keys and group dial keys are stored on "index cards". A key can be accessed by touching
its card. (p.8)
Caution
To prevent calling or sending a fax to a wrong number, look carefully at the touch panel and make
sure that you enter the correct number when programming an auto-dial number. You can also
check programmed numbers by printing out an address list or group list after programming (p.80).
REDIALING
The last number dialled can be redialled by simply pressing the [REDIAL] key.
The machine keeps the last number dialled with a rapid key or the numeric keys in
memory. However, when an F-code transmission is performed, the machine only
retains the fax number; it does not retain the sub-address or passcode.
• If numeric keys were pressed during a phone conversation, the [REDIAL] key may
not dial the correct number.
• The number is not retained when the following special operations are performed (the
last number that was dialled before the special operation is retained):
• Broadcast transmission
• Serial polling
• Timer transmission
• Group dialling
KER
REDIAL
100%
TION
ADDRESS
BOOK
SUB ADDRESS
ON-HOOK DIALLING
This feature allows you to dial without lifting an extension phone connected to the
SPEAKER
machine. Touch the [SPEAKER] key, listen for the dial tone through the speaker, and
then dial.
AX MEMORY:100%
• Faxes must be sent manually when using on-hook dialling. (p.62)
AUTO RECEPTION
• A number that includes a sub-address or passcode cannot be dialled by on-hook
dialling.
RED
ADD
BO
SUB AD
11
1