Download Setra Systems SRPM Operating instructions

16
LOGIN
Menu Tree
(Shown with Password Entry)
No
No
Yes
Pressure is normal, the
screen is Green
4
10 Secs
Down
Cancel
Up
30 Secs
Calibration Screen
Apply Parameters or
“Restore Factory Setting”.
Apply Zero
ZERO
Pressure
Apply Full Scale SPAN
Pressure
Restore
Exit Factory Setting
-0.026 “WC
Negative Room
-0.02
Reset
Menu
Reset
-0.04
Pressure falls outside of
preset limits (alarmed state),
the screen is Red
-0.02
Silence
-0.04
Pressure is normal and door is
open, the screen is Yellow
Menu
–0.001” WC
Silence
Back
Calibration
Self Test
Setup Alarm
Setup Room
CALIBRATION
MENU
–0.021” WC
Door Open
MENU
Setup Unit
Main Menu
Screen
Negative Room
Alarm Setup Screen
Enter Parameters
Select “Save” to exit.
Save & Exit
Volume
Alarm Delay
Mute Time Out
Door Alarm Input Yes
No
Yes
Audible alarm
Password
Entered
Correctly
Negative Room
Door Open
Cancel
MENU
SETUP
ALARM
OK
Latch Alarm
Normal, Warning, and Alarm Condition Screens
Enter Parameters
Select “Save” to exit.
Setup Room Screen
Setup Unit Screen
Enter Parameters
Select “Save” to exit.
Data Entry Sreen
Login Sreen
Cancel
LOGIN
Enter Password
User!
Password Not
Entered Correctly
LOGIN
OK
Cancel
Wrong Password
Entered, Re-enter
the Password
OK
Enter Password
Usr!
Enter Password
Wrong password
entered or Number
of Tries Exceed the
Maximum Number
of Tries. Return to
Pressure Monitoring
Screen
Pressure Monitoring
Screen
Menu Button Pressed
WelcomeScreen
Self Test Screen
Test Alarm
6.0 Electrical Installation
6.1 Analog Output (J5)
SRPM can be configured as current (4 to 20 mA) or voltage (0 to 5 or 0 to 10 VDC).
Voltage output pin 1, Current output pin 2, Common pin 3. Note. No external
excitation is required.
1 V Out 0 to 5, 0 to 10 VDC
2 C Out 4 to 20 mA
3 Common
Figure 11: Analog Output (J5)
13