Download 35% Extra 260 Assembly Manual_SAE

6.
Gather the plywood canister mount and silicon
tube for vibration isolation mounts. Cut 8 1”
pieces and slide into the plywood cutouts in
the canister mount. Canister mount available
from canister or engine manufacturer.
8.
Canister mount should align with canister tunnel under main landing gear mount.
7.
Position canister mount against backside of the
landing gear former.
9.
Install headers, couplers, clamps, and canisters
to get a good dry fit before gluing plywood
canister mount to the back of the main landing
gear former. Cut exit holes for canister stinger
exhaust pipes if necessary. This will only be
necessary with front exit canisters.
52