Download Wolf ICBDD30 Installation guide

DOWNDRAFT VENTILATION
Contents
2Downdraft
Ventilation
3Specifications
4Installation
6Troubleshooting
Important Note
Product Information
To ensure this product is installed and operated as safely
and efficiently as possible, take note of the following types
of highlighted information throughout this guide:
Important product information including the model and
serial number are listed on the product rating plate. The
rating plate is located next to the blower housing on the
front side of the downdraft, below the countertop. Refer to
the illustration below.
IMPORTANT NOTE highlights information that is especially
important.
CAUTION indicates a situation where minor injury or product
Features and specifications are subject to change at any
time without notice. Visit wolfappliance.com/specs for the
most up-to-date information.
damage may occur if instructions are not followed.
If service is necessary, contact Wolf factory certified service
with the model and serial number.
WARNING states a hazard that may cause serious injury or
death if precautions are not followed.
RATING PLATE
IMPORTANT NOTE: Save these instructions for the local
electrical inspector.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
Installation work and electrical wiring must be
a)
done by qualified person(s) in accordance with
all applicable codes and standards, including
fire-rated construction.
b)Sufficient air is needed for proper combustion and exhausting of gases through the flue
(chimney) of fuel burning equipment to prevent
back drafting. Follow the heating equipment
manufacturer's guideline and safety standards,
and the local code authorities.
c)
When cutting or drilling into wall or ceiling, do
not damage electrical wiring and other hidden
utilities.
Rating plate location.
2
|
English
d)Ducted fans must always be vented to the
outdoors.