Download Sharp R-305MR Specifications

ii:ii! ii i iit
Figure 7
Upflow
¸
Trap Configuration
Vent Pipe Clamp
Vent Elbow Clamp
Condensate Trap
Relief Port
Elbow
Plugs
Collector Box
Plug
p
Relief Port
Pressure Switch
Port
Outlet
UPFLOW TRAP CONFIGURATION
MODULATING
Representative
To Relocate
the Condensate
drawing
only some
3. Refer to the
conversion.
appropriate
trap and tubing before
figure
to
begin
the
trap
4. Remove the relief tube from the condensate trap.
5. Remove the screw that secures the condensate
the collector box.
9. Remove the pressure switch tube from the stand-offs
the inducer assembly
on
10. Loosen the clamp around the inlet of the vent elbow on
the inducer.
11. Remove the middle and bottom plugs from the lower
right side of the collector box and set aside. Do Not
Discard Plugs.
Specificati .....
appropriate
figure
to
begin
the
trap
13. Install the two (2) plugs previous removed from the
collector box in the ports where the condensate trap was
removed.
14. Install the trap over the ports on the lower right side of
the collector box.
15. Secure the trap to the collector box with the screw.
trap to
6. Remove the trap.
7. Remove the relief tube from of the port on the collector
box. It is not necessary to remove the hose from the
inducer assembly.
8. Remove the pressure switch tube from the port on the
collector box.
440 01 4201 01
Al1306
models may vary in appearance.
12. Refer to the
conversion.
Trap:
1. Orient the furnace in the downflow position.
2. Figure 8 shows the condensate
and after relocation.
UN{TS
16. Connect the relief tube to the condensate
relief port of the condensate trap.
trap to the
17. If necessary, slide the relief tube in the
stand-offs to adjust the position of the tube.
inducer
18. Connect the relief tube to the relief port
condensate trap.
19. Route the pressure switch tube to the port
collector box next to the condensate trap. Trim
excess tube to avoid sags or kinks in the tube.
20. Rotate the vent elbow to the desired position and
the clamp 15 in.-Ibs.
21. Refer to Condensate Drain section for information
install the condensate drain.
of
bject to change without
notice.
the
on the
off any
tighten
how to
11