Download Clarion SR6000 Programming instructions

UNGO – Remote Programming
1-12
1-13
Code Hopping ON
Channel 4 Validity (1)*
MENU 2
Feature
Default LED ON
Number
(Press Channel 1)
2-1 Engine Check ON
2-2 Tachometer Sensing
2-3 12 Minute Run Time (1)*
2-4 Flashing Parking Light Output
2-5 Cranking Time 0.6 Sec. (1)*
2-6 Voltage Check Level High
2-7 Short Run (Turbo Timer): 1 Min. (1)*
2-8 Activation Pulse: 1 (1)*
2-9 2nd Ignition Output
2-10 Accessory State During Wait to Start: OFF
2-11 2nd Status Output: Normal (1)*
2-12 Anti-Grind ON
Note: Factory default settings are shown BOLD.
Note: * The number in parentheses indicate the number
Code Hopping OFF
Latched (2)*, Latched Reset with Ignition (3)*,
30-Second Timed (4)*
LED OFF Setting
(Press Channel 2)
Engine Checking OFF
Voltage Sensing
24 Min (2)*, 60 Min Run Time (3)*
Constant Parking Light Output
Crank Time 0.8 (2)*, 1.0 (3)*, 1.2 (4)*, 1.4 (5)*,
1.6 (6)*, 1.8 (7)*, 2.0 (8)*, 4.0 (9)*
Voltage Check Level Low
Short Run (Turbo Timer): 3 (2)*, 5 (3)*, 10 (4)*
Activation Pulses: 2 (2)*, 3 (3)*
2nd Accessory Output
Accessory State During Wait to Start: ON
Rear Defogger Latched (2)*, Pulsed (3)*
Anti-Grind OFF
of times the LED will flash.
Remote Programming
158