Download Cooper Security 9751 User guide
Transcript
4. Programming 33: System Reset If you wish to make the system engineer reset, then use option 1. For user reset use option 0. Certain types of event will always need an Engineer reset, no matter what option you choose for Command 33. These events are: Auxilliary 12V supply fuse blown. Keypad missing or failed. A low battery at the control unit. 34: PA Reset If you wish to make the system engineer reset after a PA alarm then use option 1. For user reset use option 0. 35: First Circuit Response If you select option 0 (Lock out) then the complete system rearms at the end of the programmed bell run time, but excludes the first zone to activate during the set cycle. If you select option 1 (Re-arm) then, when an alarm occurs, the complete system (including the first zone to activate) rearms at the end of the programmed bell run time (providing the zone is closed). While the zone is open, the system locks it out. If the zone closes after the system rearms, the system reinstates it. 36: Alarm Abort Users occasionally trigger false alarms by accident. The control unit can be programmed to allow users to abort an alarm by enabling option 1. If a user accidentally triggers an alarm while the system is set, then the control unit activates Channel 3, starts the bell delay timer and alarm abort timer. To abort the alarm the user must enter a valid access code during the abort period. When the user successfully enters the code during the abort period the system deactivates Channel 3 and triggers the programmed abort channel simultaneously in order to signal a separate code abort, as required by some ARCs. Note: The alarm abort period is controlled by the ARC at 120 seconds. 37: Daytime Tamper Communication This Command controls how the control unit reports tampers while the alarm system is unset. With option 1 selected the system communicates tamper events to the ARC and starts the internal sounder. With option 0 selected the system starts the internal sounder only. 496929 Page 33