Download Sigma S2Ba Operating instructions
Transcript
Dulcodes UV-Desinfektionsanlage Product description S2Ba/S2Ca The liquid end can continue to operate in emergency mode, i.e. full operating pressure, no leakage, even after diaphragm rupture, until the diaphragm has been replaced. We offer two versions of the S3Ca with diaphragm rupture sensor: • After a working diaphragm rupture, the pump stops and an ”error“ message/diaphragm sensor signal is given. • After a working diaphragm rupture, the pump will continue to run. An ”error“ message/ electrical signal is given. A function plug is supplied which allows the pump to continue operating after a fault has occurred (diaphragm rupture, failure of the diaphragm rupture sensor). WARNING • EX-pump only: Installations in potentially explosive atmospheres must be inspected by a “accredited qualified” person. This applies in particular also for intrinsically safe electrical circuits. • EX-pump only: observe documents supplied with the sensor! IMPORTANT • In the case of the S2Ba, the customer should install a diaphragm rupture signal monitor and/or ensure that the pump will stop after a diaphragm rupture. • In the event of diaphragm failure, a contact signal is triggered as from 2 bar system backpressure. • Exact pump delivery can no longer be guaranteed after failure of the working diaphragm. • The auxiliary diaphragm, Item 148, is a wearing part and must be replaced after failure of the working diaphragm. The diaphragm rupture sensor lens, Item 156, should be replaced after every diaphragm rupture. 111 103 112 147 118 148 203 149 204 150 200 201 100 159 110 117 101 113 156 157 155 158 160 114 115 161 116 162 FM 130 Identcode Type: 12050, 12090, 12130, 16050, 16090, 16130 FM 350 Identcode Type: 04350, 07120, 07220 ® ProMinent 104 163 Fig. 8 3162-4 Page 23