Download Sigma S2Ba Operating instructions

Transcript
Dulcodes UV-Desinfektionsanlage
Product description S2Ba/S2Ca
The liquid end can continue to operate in emergency mode, i.e. full operating pressure, no
leakage, even after diaphragm rupture, until the diaphragm has been replaced. We offer two
versions of the S3Ca with diaphragm rupture sensor:
• After a working diaphragm rupture, the pump stops and an ”error“ message/diaphragm sensor
signal is given.
• After a working diaphragm rupture, the pump will continue to run. An ”error“ message/
electrical signal is given.
A function plug is supplied which allows the pump to continue operating after a fault has
occurred (diaphragm rupture, failure of the diaphragm rupture sensor).
WARNING
• EX-pump only: Installations in potentially explosive atmospheres must be inspected by a
“accredited qualified” person. This applies in particular also for intrinsically safe
electrical circuits.
• EX-pump only: observe documents supplied with the sensor!
IMPORTANT
• In the case of the S2Ba, the customer should install a diaphragm rupture signal monitor
and/or ensure that the pump will stop after a diaphragm rupture.
• In the event of diaphragm failure, a contact signal is triggered as from 2 bar system
backpressure.
• Exact pump delivery can no longer be guaranteed after failure of the working diaphragm.
• The auxiliary diaphragm, Item 148, is a wearing part and must be replaced after failure
of the working diaphragm. The diaphragm rupture sensor lens, Item 156, should be
replaced after every diaphragm rupture.
111
103
112
147
118
148
203
149
204
150
200
201
100
159
110
117
101
113
156
157
155
158
160
114
115
161
116
162
FM 130
Identcode Type: 12050, 12090, 12130, 16050, 16090, 16130
FM 350
Identcode Type: 04350, 07120, 07220
®
ProMinent
104
163
Fig. 8
3162-4
Page 23