Download Utax CD 1325 User guide

Sending Functions
Finish Notice
This feature sends an e-mail providing notification that transmission has
been completed.
Use the procedure below to specify the Finish Notice settings.
1
Place the originals on the platen.
2
Press the Send key.
3
Press [Advanced Setup] and then [Job Finish Notice]
4
To select the
destination from the
address book, press
[Address Book] on
the left of the screen
and then press
[Address Book] in
the next screen.
Select the
destination to be
notified, then press
[OK].
Ready to send.
Destination
Place original .
1
Job Finish Notice
Off
Destination
Address Book
Detail
Address
Entry
Detail
Add Shortcut
Address Book
Cancel
Status
OK
10/10/2007
10:10
You can view information on the notification destination by pressing
[Detail].
5
Specify the destination to send the finish notice, and press [OK].
NOTE: For the procedure to select the destination from the Address
Book, refer to the Operation Guide.
6
To directly enter the
address, press
[Address Entry] and
then [E-mail
Address].
Ready to send.
Destination
Place original.
1
Job Finish Notice
Off
Address Book
E-mail
Address
Address
Entry
Add Shortcut
Status
2-32
Cancel
OK
10/10/2007
7
Enter the E-mail address, and press [OK].
8
Press [OK].
10:10
ADVANCED OPERATION GUIDE