Download VMware GSX Server 3 Administration Specifications
Transcript
VMware GSX Server Virtual Machine Guide This keeps dhcpd from probing for all available network interfaces. If the above solutions do not work for your DHCP server program, then it likely is old. You can try upgrading to a more current version such as the DHCP software available from the ISC Web site at www.isc.org. DHCP and Dynamic Domain Name Service (DDNS) DHCP can be used to hand out IP addresses as well as other information, such as the identity of a host running a name server and the nearest router or gateway. The DHCP server in GSX Server does not provide a means to dynamically establish a relationship between the IP address it assigns and a client’s name (that is, to update a DNS server using DDNS). If you want to use names to communicate with other virtual machines, you must either edit the DHCP configuration file for VMnet1 (/etc/vmware/vmnet1.conf ) or use IP addresses that are statically bound to a host name. Editing the DHCP server configuration file requires information that is best obtained directly from the DHCP server documentation. Consult the manual pages dhcpd(8) and dhcpd.conf(8). Setting Up a Second Bridged Network Interface on a Linux Host If you have two Ethernet adapters installed on your host computer, connected to two different networks, you may want your virtual machines on that host computer to bridge to both Ethernet adapters so the virtual machines can access either or both physical networks. When you install GSX Server on a host computer with multiple Ethernet adapters, you have the option of configuring more than one bridged network. You can also configure additional bridged networks at any time by rerunning vmwareconfig.pl. 1. On the host computer, become root (su -) and run the GSX Server configuration program. vmware-config.pl Caution: In order to configure GSX Server correctly, the vmware-config.pl configuration program requires all virtual machines to be shut down. The program shuts down any running virtual machines automatically. 2. If you have more than one physical Ethernet adapter, one of the prompts you see is similar to this: The following bridged networks have been defined: . vmnet0 is bridged to eth0 258 www.vmware.com