Download AGA LPG Technical data

COOKER PART AND FINISH
CLEANING METHOD
Self-Clean Enamel
This special enamel has a continuous
cleaning action, which works best if a pattern
of low and high temperature cooking is
followed. By using low temperature roasting,
excessive fat splashes can be avoided.
Should any excessive staining occur,
immediately clean the area with hot water
containing detergent, and a nylon washingup brush. Resistant stains require the oven
to be run at 210°C for 2 hours.
Fan Oven, Conventional Oven, Simmering
Oven: sides, top and back
Grill Compartment: sides and back
DO
NOT
USE
ANY
CLEANING
MATERIALS WHICH MAY CLOG THE
PORES OF THE SPECIAL COATING e.g.
PASTES AND POWDERS, SOAP-FILLED
PADS, WIRE WOOL, SPRAY CLEANERS,
BRUSH-ON OVEN CLEANERS, CAUSTIC
SOLUTIONS, METAL SCRAPERS/KNIVES,
AND PREVENT THE CONTINUOUS
CLEANING ACTION.
As for enamel cleaning. Do not place in a
dishwasher
Aluminium
Right & left rear outer burner caps
Right front outer burner cap
Centre front outer burner cap
NOTE: Care must be taken to prevent
cleaning materials, water or dirt, from
entering and blocking the burner head, ports
and especially the gasway. Remove any
blockage with a fine needle or nylon brush.
Non-Stick Coating
Soak and wash in hot soapy water.
Griddle plate
DO NOT USE ABRASIVES OR PLACE IN A
DISHWASHER.
FIG. 16
DESN 512935 A
44