Download Audiovox Skybox User manual

Appendix A Installing TNC Connector to RG58 Cable
Procedures for
Installing TNC
Connector to
RG58 Cable
These procedures were written using
Jye Bao Co. 8.7” Hex series crimp
tool (CT-001) and TNC connectors
(TNC3100-0058).
1. Strip the RG58 cable back 16.4mm
from the end of the cable. Trim the
braid back 8.2mm from the end. Strip
the foam insulator back 4.7mm from the
end of the cable.
4. Solder the center pin to the cable’s center
conductor at the hole on the pin.
5. Fold the braid back from the cable.
6. Slide the Connector onto the cable.
2. Slide the ferrule over the RG58 cable.
Connector
Ferrule
3. Place the center pin onto the center conductor of the cable.
7. Slide the ferrule up to the connector and
crimp.
Center Pin
Skybox Installation & User Manual
31