Download Samson CR4 Specifications
Transcript
Guided Tour - CRND Receiver 1 2 3 4 5 ANTENNA TX ON SQUELCH PEAK VOLUME 4 5 6 3 7 8 2 min max CONCERT ND VHF RECEIVER POWER 6 9 1 0 Channel 16 10 SAMSON 2: “TX ON” LED - Lights when carrier signal of sufficient strength is being received by the CRND. 3: Squelch control - This control determines the maximum range of the CRND before audio signal dropout. It should normally be left at its factory setting. For more information, see the “Setting Up and Using the Concert IV System” section on page 6 in this manual. 4: Peak LED - This LED lights when output signal from the CRND is at the onset of clipping (that is, when it is on the verge of being distorted). If you see this light during operation, move the microphone further away or lower the output level of your instrument or transmitter. For more information, see the “Setting Up and Using the Concert IV System” section on page 6 in this manual. 5: Volume - This knob determines the level of the audio signal sent from the unbalanced output jack on the rear panel. 6: Power LED - Lights whenever the CRND is powered on. 7: DC input - Connect the supplied AC adapter here. WARNING: Do not substitute any other kind of power adapter; doing so can cause severe damage to the unit and will void your warranty. 8 7 DC INPUT 12V 1.2 W(100 mA) 8: Unbalanced output - Use this unbalanced high impedance (5K Ohm) 1/4" jack to connect the CRND to the microphone input of your mixer. The jack is wired as follows: tip hot, sleeve ground. UNBALANCED OUTPUT PLUG LOCK FOR AC ADAPTER 9 ANTENNA RECEIVER SAMSON MADE IN U.S.A. + - -10 dBv 5 K Ω CAUTION USE 12 VDC OUTPUT ADAPTER ONLY 9: Rear-mount antenna knockout - The CRND antenna (normally mounted on the front panel) can optionally be mounted on this area of the rear panel. Contact Samson or your local distributor for further information. Rack-mounting the CRND As shown in the illustration below, one or two CRND receivers can be mounted in a single 19" rack space with the use of an optional adapter available from Samson or your local distributor. POWE VOLUM 5 PEAK SQ UELCH NA min max 6 7 8 2 9 1 TX ON ANTEN T lV ERIVE R COFNC RECE R E 4 3 Ch an ne l 16 10 0 VH SON SAM 5 ENGLISH 1: Antenna mounting - Connect the supplied antenna to this mounting. Third-party receiver antennas should not be substituted—use only the antenna provided with the CRND. See the “Setting Up and Using the Concert IV System” section on page 6 for more about antenna installation and positioning.