Download Multitech MTCBA-C-IP-N1 Specifications

ENHANCED IP STACK EXTENSIONAT COMMANDS through #GSMCONT. Format is: #GDATAVOL: <cidn>,<totn>,<sentn>,<receivedn>[<CR><LF>#GDATAVOL: <cidm>,<totm>,<sentm>,<receivedm>[…]] 2 Reports the total GPRS data counter, since last reset, for the all the set PDP contexts (that is, all the PDP context with APN parameter set using +CGDCONT) and the total GSM data counter for the GSM context, if set through #GSMCONT. Format is: #GDATAVOL: <cidn>,<totn>,<sentn>,<receivedn>[<CR><LF> #GDATAVOL: <cidm>,<totm>,<sentm>,<receivedm>[…]] Reporting parameters are as follows: <cidn> PDP context identifier. 0 Specifies the GSM context. 1‐5 <totn> <sentn> <received> Numeric parameter which specifies a particular PDP context definition. Number of bytes either received or transmitted in the last GPRS (or GSM) session for <cidn> PDP context. Number of bytes transmitted in the last GPRS (or GSM) session for <cidn> PDP context. <receivedn> ‐ number of bytes received in the last GPRS (or GSM) session for <cidn> PDP context. Notes „
Last GPRS and GSM session counters are not saved in non‐volatile memory so they are lost at power off. „
Total GPRS and GSM session counters are saved in non‐volatile memory. ICMP Ping Support #ICMP Set command enables or disables the ICMP ping support. Read command returns whether the ICMP ping support is currently enabled or not, in the format: #ICMP: <mode> Test command reports the supported range of values for the <mode> parameter. Syntax Command Command type AT#ICMP=<mode> Set AT#ICMP? Read AT#ICMP=? Test Parameters and Values <mode> 0 1 2 261 Disable ICMP ping support. Default: 0. Enable firewalled ICMP ping support. The module is sending a proper ECHO_REPLY only to a subset of IP Addresses pinging it. The #FRWL specifies is subset of IP addresses. Enable free ICMP ping support. The module is sending a proper ECHO_REPLY to every IP address pinging it. HSPA+ AT Commands Reference Guide