Download Schmid Watson Specifications

Watson-TDM-Manual-W.doc
Watson TDM
Operating Manual
Version 2.0-01
CONFIG
The CONFIG command displays the current configuration of the modem:
LTU_01_CM>CONFIG
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Local Configuration
Id : 2 MBit/s G.703
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
2 MBit/s
Framing
: ITU-T G.704
CRC4
: On
E-Bit Insertion : On
AIS Generation : On
AIS Detection
: On
Clock Mode
: Local 2Mbit Port
Data Rate
: 01 x 64 = 00064 kbit/s
TS Mapping Mode : 2
SHDSL
Master/Slave
: Master
Autorestart
: Enabled
Power Backoff
: Disabled
Payload Rate
: 00192 kbit/s
Operating Mode : 1 Pair
Line Rate
: 00208 kbit/s
Remote Powering : On
Regenerators
: -TMN
Address
: 01
V.11 wires
: 02
Management
Admin Name
: ZRHBINZ35
Notes:
•
•
•
After each configuration change, the new configuration is automatically displayed.
If the DSL clock mode is set to "Network reference" (LTUMODE N) then the
this is shown in the Operating Mode line
For tabletop modems the wetting current status (wetting current sink on/off)
is shown instead of the Remote Powering status
When both an nx64 kbit/s and an E1 interface are equipped, the configuration
display shows first the E1/PRA configuration and then the nx64 kbit/s configuration, e.g.:
LTU_01_CM>CONFIG
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Local Configuration
Id : Multiservice
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
2 MBit/s
Framing
: ITU-T G.704
CRC4
: Off
E-Bit Insertion : -AIS Generation : On
AIS Detection
: Off
Data Rate
: 11 x 64 = 00704 kbit/s
X.21
Bitrate
: 20 x 64 = 01280 kbit/s
Clock Mode
: Remote
Clock Polarity : Normal
Byte Timing
: Off
Handshake
: Disabled
SHDSL
Master/Slave
: Slave
Autorestart
: Enabled
Power Backoff
: Disabled
Payload Rate
: 02048 kbit/s
Operating Mode : 1 Pair
Line Rate
: 02056 kbit/s
Revision: 2008-02-07
8-3