Download Security System Administrator`s Guide

Administration
i-on40
Downloader. Your alarm system is programmed to call two
different telephone numbers. You do not have to know these
numbers, your Installer will tell you to select one of them.
To start the call:
1.
Enter the User Menu and select System Config - Call Downloader.
The display shows the Call to Downloader menu.
2.
Select Telephone Number 1 or 2, or IP Address 1 or 2 as
instructed by your installer.
The control unit calls the installer's computer on the number
you selected.
Your system may be connected to Downloader for several
minutes.
When Downloader has finished and the connection is broken
the display shows the time and date.
Redirecting Speech Messages
Note: This option appears only if you have the a speech dialler
module fitted inside the control unit.
If you need to re-direct speech messages to new telephone
numbers then:
1.
Enter the Menu and select System Config - Speech Phone Book.
The bottom line of the display shows “Tel No 1”.
2.
Press u or n to scroll through the available telephone
numbers, followed by > to gain access to an individual
number.
The bottom line of the display shows the current digits of the
telephone number.
3.
Key in the new telephone number from the keypad. If
necessary, press u to move the cursor left, or n to move
the cursor to the right. Press < to remove digits to the left of
the cursor.
4.
Press Y to store the changes you have made.
Page 30