Download Simons Voss Technologies Palm LDB Version 1.40 Unit installation

Smart Relay: SREL, SREL.ZK, SREL.ADV
External access control or time
recording system
Page 18
8.0
Serial Interface
8.1
Functional Description
In order to use a Smart Relay as a card reader in an external access control or time
recording system, both the hardware (cable and signal level) and the data formats
must correspond exactly to those of the card reader. Only then can the external
system understand and evaluate the data from the SimonsVoss transponders.
First the Smart Relay reads the transponder data. If the transponder is authorised in
the Smart Relay, this data is forwarded to the external system via the serial interface.
SimonsVoss Product Management will provide you with detailed specifications for the
individual data formats.
You can select the correct reader type in the Smart Relay configuration using the
SimonsVoss software, version 1.40 and later. The following sections describe the
connections for the different reader versions.
8.2
Wiegand Interface (32 bit and 26 bit)
External
access control oroder
Externes
Zutrittskontrolltime recording system
Zeiterfassungssystem
GND
+ 5..12VDC
1K
1K
1K
Pull-up
resistors
Pull
Up Widerstände
CLS
D1
D0
Power
Netzteil
{ +- // ~~
F2 F1
Battery
BatterieSREL.BAT
SREL.BAT
Relay
Relais
{
NC
COM
NO
Brown
White
Green
Grey
Yellow
}
Externe
External Antenne
antenna
SREL.AV
SREL.AV