Download DR Electric-Start - Self-Propelled Operating instructions
Transcript
Adjusting the Cutting Height WHEN USING THE PTA™ FEATURE, INSTALL THE CUTTING CORDS IN ONE OF THE FOUR BOTTOM LINE PLATES ONLY. Adjusting the cutting height is easy. Cutting heights range in 1/2-inch increments from 1-1/2 inches when using the bottom Line Plate, to approximately 4 inches when using the top Line Plate (Figure 14). Install the Cutting Cords in the Line Plate that gives you the desired cutting height. Figure 14 The Mow-Ball™ Support Allow the front end of the machine to rest lightly on the Mow-Ball™ Support as you are trimming. The Mow-Ball™ Support should glide on the ground as you maneuver the machine. To achieve the best and smoothest cut, do not lift up on the Handlebar while operating your DR TRIMMER/ MOWER. Lifting the Handlebar will force weight down on the Mow-Ball™ Support. This uses more energy, slows the cutting, and produces an unsatisfactory cut. Ideally, the Mow-Ball™ Support should lightly rest on the ground while the wheels balance most of the weight of the machine (Figure 15). Figure 15 CALL TOLL FREE 1-800-DR-OWNER 25