Download Eagle 1241 Specifications
Transcript
1 MIN ALERT TONES CUT TO DISABLE EAGLE SECURITY MODEL 1241 P5 1 2 3 4 5 6 P7 INCREASE 2 1 AUDIO ACTIVE INCREASE P4 IN USA ON OFF 3 4 P3 3 2 1 SPEAKER VOLUME 1 4 3 2 6 5 2 1 1 4 3 2 6 5 P6 P2 P1 SPK SPK MIC4 MIC3 SHLD MIC2 MIC POWR N.C. RELAY YELLOW BLUE BARE YELLOW BLUE BARE 1 4 3 2 (brown) TELCO TIP YELLOW BLUE BARE YELLOW BLUE BARE -12 VDC (NEG) SWITCHED +12 VDC FROM CONTROL PANEL FROM CONTROL PANEL RJ31X OR RJ11 TELCO JACK ONE OF THE EAGLE TRIP MODULES (1405 or 1406). IF A TRIP OUTPUT IS NOT AVAILABLE USE TRIP OUTPUT ON THE DIALER (IF AVAILABLE). THE TRIGGER INPUT IS CONNECTED TO A - + MICROPHONE 1 or AMPLIFIED MIC (see NOTE: 1) SIREN DRIVER MODULE MIICROPHONE 2 (optional) MICROPHONE 3 (optional) MICROPHONE 4 (optional) (if any) Cut the shorting bar across pins 1 & 2 for an amplified mic. P3 is used to select which type of mic input is being used. Leave the shorting bar across Pins 1 & 2 for the electret mic. sound discriminators. electret mic or an amplified microphone such as found on some NOTE: 1 - Terminal 9 can be used in conjuntion with either a 3 pin +12 VDC (GROUND) (NEG) (gray) -12 VDC AUDIO SPEAKER OBSERVE POLARITY SIREN SPEAKER TELCO RING TRIGGER INPUT ANSWER/HANGUP INPUT N.C. SIGNAL 1 POWER (+) SIGNAL 2 SHIELD (-) SIGNAL 3 SIGNAL 4 SPEAKER (-) SPEAKER (+) RELAY MIC1 1 2 P8 GND N.C. MICROPHONE VOLUME ERTH N.C. ANS HGUP TRIP RING TIP GND Page 11 +12 SW1 DIAGRAM 2: WIRING SCHEMATIC. To extend the Two Way shut down time (reset to 5 minutes), press and release 7 at any time during the Two Way (before the module disconnects). Additionally, anytime a command is sent to the Model 1241 (a 1 , 2 , 3 , 7 or #0 ) the module will automatically reset the five minute timer. The only time the 7 command need actually be MADE 1 2