Download Asus E500-PIB User`s guide

AD-Series Locks and Controllers
Lock Properties
EDIT Tab
AD-300 (Networked Locks)
Property
Description
Default
RS485 Address
Set the RS-485 network address of the lock. 0-255
0
ACP Timeout
Time (in seconds) to wait before determining communication from the ACP has
failed.
3 seconds
Comm Loss Fail Mode
Lock state set when communication from the ACP fails. As-Is, Secure/Locked,
Unsecure/Unlocked
As-Is
Power Failsafe Mode
Lock state set when power to the lock fails. As-Is, Secure/Locked, Unsecure/
Unlocked
As-Is
Degraded (Cache)
Mode: Card Bit Format
Number of bits in the credential card number. 0 = cache mode disabled
0
Degraded (Cache)
Mode: Full Card Number
or Facility Code
Use the full card number or the facility codes of previously approved credentials in
the Degraded (Cache) mode.
Disabled
Degraded (Cache)
Mode: Purge unused
after 5 days
When enabled, deletes the cache entry after 5 days of non-use.
Disabled
Degraded (Cache)
Mode: Clear Cache
Deletes all valid user credentials from the Degraded (cache) memory.
n/a
Max Entries Stored
Number of credential cards maintained in the cache. Minimum of 5, Maximum of
1275
125
Disable Interior Button
LED
If checked, interior button LED blinking is disabled.
LED is
Enabled
(unchecked)
Relock Delay
Amount of time before the lock relocks after being unlocked by a user presenting a
valid credential.
3 seconds
Relatch After:
Timer/ Door Status
Re-latch on:
• Timer Only (Lock when timer expires regardless of Door status or Position)
• On Door Open or Timer (Lock when the Door opens or Timer expires)
• On Door Close or Timer (Lock when the Door closes or Timer expires)
Timer only
Card + PIN LED mode
Disabled
Mode 1: 2 alternating blinks
Mode 2: Solid Green/2 red blinks
1
Communication Link
Direct to Host: Sets RS-485 communication protocol to work directly with an ACP.
Through PIB300: Sets RS-485 communication protocol through the PIB300.
Direct to Host
27 • Schlage • Schlage Utility Software User's Guide