Download Savin DSc432 Operating instructions

ThemisC1_EN_zentai_pre_FM.book Page 146 Thursday, June 30, 2005 8:21 PM
Remarks
Maintaining Your Machine
If the exposure glass or ADF is dirty,
copy clarity may be reduced. Clean
these parts if they are dirty.
Cleaning the ADF
❖ Cleaning the machine
Wipe the ADF with a soft dry
cloth. If stains remain, wipe with a
well-wrung wet cloth, and then
wipe the water off with a dry cloth.
If the stains cannot be removed
with water, use a neutral detergent.
Important
❒ Do not use chemical cleaners or organic solvents, such as thinner or
benzene. If such substances get inside the machine or melt plastic
parts, a failure might occur.
❒ Do not clean parts other than those
explicitly specified in this manual.
Other parts should be cleaned only
by your service representative.
7
Cleaning the Exposure Glass
ZGJS827E
Clean 1 and 2.
Cleaning the Guide Boards
R CAUTION:
• The inside of the machine becomes very hot. Do not touch the
parts with a label indicating "v"
(means hot surface). Touching
"v" (means hot surface) could
result in a burn.
A Turn off the main power switch.
B Open the Bypass Tray.
ZGGH420E
Clean 1 and 2.
AFS032S
146