Download DCS DD24DUT7 User guide

3
5
OPTIONALLY HARD WIRING PRIOR TO INSTALLATION
3a REMOVE THE LOWER DRAWER
3b REMOVE THE ACCESS COVER & POWER CORD
43
4
5
Access
cover
1
6
8
To prevent kinked hoses, we recommend
rotating the drawer anti-clockwise and
resting 5
it on its side after removal.
mm)
0m
41”0(100m
2
7
WARNING!
Press the release tabs in on
either side and push back
to release drawer from
runners.
Electrical Shock Hazard
Before continuing, ensure that the product is
disconnected from the power supply.
Failure to follow this warning may result in
electrical shock, injury or fire.
8
3c TERMINATE THE WIRING AS SHOWN
3d REFIT THE DRAWER ONTO THE RUNNERS & CLOSE
Remove knock-out for cable clamp and
fit a suitable cable clamp for the conduit.
e tabs
releas
rd the 00 mm)
a
w
r
Pull fo sides 4”(1
th
on bo
Ensure the drawer
is now rotated
clockwise back.
15
16
Before refitting the drawer,
ensure the hoses are not
twisted and the latches at
the rear of each drawer
runner are facing forward.
11
19
11
10
9
12
13
Use copper conductors only.
7
Ensure the release tabs on
both sides are reset fully.
14