Download EFD 900 Installation manual

Evolution Flight Display System AFMS
NOTE:
ADAHRS alignment begins at power up. Avoid movement during ADAHRS
alignment as this will delay and degrade the ADAHRS initialization. Attitude
and heading data is presented once alignment is complete.
NOTE:
When in the “DISC” position, the EBB isolation relay is powered from the
EBB. When the switch is in the disconnect position the Emergency Backup
Battery will gradually discharge.
NOTE:
MFD database features load incrementally after power up. Loading progress
is indicated at the bottom of the Nav Map.
4.3
Before Take-Off Checks
MENU
..................................................................... “POWER SETTINGS”
Page
EXT PWR: (Aircraft Input Voltage) ................................... Check > 12.3V/24.6V
BAT: .................................................................................. Verify battery status is not
shown as “FAIL” (normally
this shows “CHARGING”
or “READY”)
PFD ................................................................................... Configure for departure
EFD1000 MFD (if installed) .............................................. Select REV and press
XFILL. Review the
Crossfill parameters and
accept the change.
In addition, if an EFD1000 MFD with EBB is installed, perform the following steps
from the Power Settings Page:
EFD1000 MFD .................................................................. Select “BATTERY”
EFD1000 MFD .................................................................. Verify Battery charge is
above 80%
EFD1000 MFD .................................................................. Select EXT PWR
MENU
DOCUMENT 900-00008-001
Date: 8/7/2012
..................................................................... Press the MENU button to
return to normal operation
PAGE 47 OF 53
REVISION R
© Copyright 2012 Aspen Avionics Inc.