Download Eiki EIP-4500 Setup guide

Stack Projection
Setting up the Stack Projection
Basic
This part shows an example for setting up the stack projection of a computer image with two projectors.
RGB cable
OUTPUT (FOR INPUT 1, 2)
terminal
Projector 1: Master
LAN terminal
INPUT 1 terminal
RGB
cable
LAN cable
(cross-over type)
Computer
Projector 2: Slave
LAN terminal
INPUT 1 terminal
1
Set the “Stack Setting” of the projector 1 to “Master”.
4
(See page 84 on the owner’s manual of the
projector.)
2
3
Select inputs as specified in the
table below.
(See page 86 on the owner’s manual of the
projector.)
Set the “Stack Setting” of the projector 2 to “Slave”.
Projector 1
Master
Slave
(See page 84 on the owner’s manual of the
projector.)
Set Inputs
INPUT1 ON
INPUT2 OFF
INPUT3 OFF
INPUT4 OFF
INPUT5 OFF
Set Inputs
INPUT1 ON
INPUT2 OFF
INPUT3 OFF
INPUT4 OFF
INPUT5 OFF
Perform “Pair Stack” of the both
projectors.
(See page 85 on the owner’s manual of the
projector.)
5
Projector 2
Turn off the both projectors.
39