Download Security Command R500 Specifications

plscpcg.book Page 194 Monday, May 28, 2001 10:11 AM
8 – Configuring Points
•
•
•
•
•
•
•
Run Hours (Algo#7)
General Logic (Algo#10)
Composite Alarm Processing (Algo#12)
Integration (Algo#15)
Cyclic Task Request (Algo#16)
Piecewise Linearization (Algo#22)
Maximum/Minimum (Algo#64)
Action Algorithms
Action algorithms initiate some action when the PV of the point to which they are
attached changes. Action algorithms are processed whenever the PV of a point
changes.
For example, say you needed to run a report when a status point changes to a
certain state. You could attach the Status Change Report Request algorithm to the
status point, and the report would be requested when the status point changed to
a nominated state.
The
•
•
•
•
•
•
•
•
•
•
•
•
•
following action algorithms are available:
Composite Alarm Initiation (Algo#11)
Down Time Analysis (Algo#65)
Value Transportation (Algo#68)
Status Change Task Request (Algo#69)
Status Change Report Request (Algo#70)
Queued Task Request (Algo#71)
Status Change USKB LED Request (Algo#74)
Status Point Notification (Algo#75)
Analog Point Notification (Algo#76)
Status Change Display Request (Algo#77)
Group Control of Points (Algo#78)
Status Change Alarm Group Inhibit (Algo#79)
Status Change Alarm Area Inhibit (Algo#80)
Sources of Information on Algorithms
For information on algorithms, refer to:
•
The Quick Builder online help for each Algorithm (see “Online Help for
Algorithms” on page 195), or
•
The Hardware and Point Build Reference.
194
R400