Download Ryger NAVIGATOR DMX Controller Specifications

Avolites Rolacue Operators Manual - page 99
•
In the User settings menu, set Option 10 to REMOTE CONTROL. The
remote control will not function correctly unless this is done.
•
•
Connect up the Stage Remote as described above.
Press the blank white key on the bottom left hand corner of the Remote.
The LED’s on the remote will flash.
•
On the remote press EXIT followed by 111. The LED’s on the remote will flash
again to show the Remote is enabled.
From the remote you may now call up DMX Channels.
The remote only functions when the key is in PROGRAM mode.
15.2 To call a single DMX channel
•
Press DIM. Its LED lights up.
•
Select the DMX number on the remote.
•
Press the AT% button.
•
Press a number form 1 to 9 to set the level or press the AT% button again
for 10 (100%).
For example, to turn DMX Channel 24 on to 70% press :
DIM 2 4 AT% 7.
To turn DMX Channel 100 on to Full press :
DIM 1 0 0 AT% AT%.
15.3 AND, THRU, INSTD, NEXT and LAST
You may create lists of Channels to turn on by using the AND button between
Channel numbers.
(Channel number) THRU (Channel number) selects all the Channels
inclusively between two Channel numbers entered.
NEXT and LAST go to the next and previous Channel to the last entered
Channel Number. All other Channels go to zero.
When using the above functions, there is no need to press the AT% button
unless you want to change the level from the previous one used. Channels
are set at the last level to be entered with the AT% button or if this has not
been used, they are set at 48%.
This level has been chosen to reduce the risk of damaging a 110 volt par lamp which
has accidentally been patched onto a 240 volt Dimmer channel.
Pressing INSTD (short for INSTEAD) will clear all Channels. (Sets all
Channels to 0%.)
15.4 Using the Remote to recall a Memory
Memories are always recalled at 100%.
•
Press MEM on the remote. Its LED lights up.
•
Enter the Playback Channel number.
rq96man 19/09/1996 18:30