Download Masterbuilt 20042011 Specifications

ASSEMBLY
ASSEMBLY
STEP 9
Slide cooking grates (12), onto
cooking grate supports (21).
STEP 3
Position burner box (6) over center
hole in bottom of smoker body,
carefully aligning venturi over valve
orifice as shown. Attach burner box
to smoker body using phillips
screws (A).
A
21
6
Firmly attach ignition wire to piezo
ignitor on control panel as shown
in Figure B.
Venturi
12
Valve Orifice
Ignition Wire
Piezo Ignitor
Figure B
STEP 4
Attach heat shield (20) to burner
box (6) using self tapping screws
(B) as shown.
STEP 10
Slide water bowl holder (11) onto
cooking grate supports (21). Place
flame disk bowl (9) into smoker as
shown.
Tighten all hardware at this time.
B
20
11
9
B
11
8