Download Cedar Summit F25650 Operating instructions

Step 26: Swing Beam Assembly
A: Attach 6 Heavy Duty Swing Hangers to (260) Engineered SW Beam using 2 (G13) 5/16 x 6-1/8” Hex Bolt
(with 2 flat washers, plastic formed washer and lock nut) per swing hanger, as shown in fig. 26.1.
B: Attach 1 Quick Clip to each Heavy Duty Swing Hanger. (fig. 26.2)
Fig. 26.1
Fig. 26.2
G13
Plastic
Formed
Washer
5/16” Flat
Washer
Quick Clip
260
Heavy Duty Swing Hanger
5/16”
Lock Nut
5/16” Flat
Washer
C: Install 4 (WB7) 5/16 x 3” Wafer Bolts (with flat washer and t-nut) in (260) Engineered SW Beam, as shown in
fig. 26.3 and 26.4. A Wafer Bolt does not get installed on the Swing Side of the beam.
IMPORTANT! MAKE SURE ALL 4 BOLTS ARE ATTACHED. THEY WILL MINIMIZE CHECKING OF WOOD.
Fig. 26.3
Fort Side
Does not get
Wafer Bolt
Fig. 26.4
WB7
260
5/16” Flat
Washer
Swing Side
5/16” T-Nut
9-3/4”
Wood Parts
1 x
260
Engineered SW Beam FSC 3 x 5-1/4 x 110”
Hardware
12 x G13
4 x WB7
5/16 x 6-1/8” Hex Bolt
(5/16” flat washer x 2, 5/16” lock nut
& plastic formed washer)
5/16 x 3” Wafer Bolt
(5/16” flat washer, 5/16” t-nut)
94
Other Parts
6 x Heavy Duty Swing Hangers
6 x Quick Clips
[email protected]