Download Viking 30AE Specifications
Transcript
(Separate Start/Stop Switches/Buttons) This application is ideal for situations in which separate switches or buttons are used to start and stop the message. 120V AC VIKING © MODEL DVA-2WA MASTER VOLUME AUX. AUDIO VOLUME VIKING ELECTRONICS HUDSON, WI 54016 4 3 5 2 1 3 SPEAKER OUTPUT 600 OHM AUDIO OUTPUT REMOTE TRIGGER PRESS AND HOLD AUTO REPEAT MIC ATTENUATION DEFAULT MSG. MESSAGE REPEAT DELAY TIMES 2 5 4 6 7 6 LED2 C LED1 PWR 1ON2 3 4S35 6 7 1 MAX MIN DIGITAL ANNOUNCER WITH 2 WATT AMPLIFIER AUX. AUDIO INPUT/ MOH START/ STOP Step 3. Use the optional Remote Stop Switch on the I.O.COM connections A & B for the “Stop” switch. MAX STATUS 12V DC Adapter included MIN RECORD AUDIO INPUT (MIC/ TAPE) Step 2. Use the “Remote Trigger Switch/Button” for the “Start” switch. POWER 12V DC Step 1. Connect speakers to DVA-2WA as shown. HANDSET REC/ MONITOR 3. On-Demand with Interruptible Announcement * Remote Stop Switch/Button (momentary SPST not included) Remote Trigger Switch/Button (momentary SPST not included) 4. Multiple Units with I.O. (Input/Output) Communication When installing multiple DVA-2WA’s in displays that are close enough together to cause audible interference, the I.O. communication will allow only one DVA-2WA to announce at a time. The last unit to be triggered will announce its message, disabling any current messages played from any previously triggered DVA-2WA. Step 1. Connect speakers and remote momentary switches to DVA-2WAs as shown in sections 1, 2 or 3 above. Step 2. Connect I.O. Com connections as shown to prevent two announcers from playing at one time. Step 3. A remote ”stop” switch can be connected to I.O Connections A & B. A momentary closure will stop message. VIKING © MODEL DVA-2WA MASTER VOLUME AUX. AUDIO VOLUME 1ON2 3 4S35 6 7 1 2 3 4 5 6 2 1 3 4 SPEAKER OUTPUT 600 OHM AUDIO OUTPUT REMOTE TRIGGER PRESS AND HOLD AUTO REPEAT MIC ATTENUATION MESSAGE REPEAT DELAY TIMES DEFAULT MSG. 6 5 * 6 7 C Optional I.O. Com connections To Other DVA-2WAs B A * Note: This connection is polarity sensitive. Optional Remote Stop Switch/Button (momentary SPST not included) C. Continuous Loop (Repetitive Information) 120V AC 12V DC Adapter included VIKING © MODEL DVA-2WA MASTER VOLUME AUX. AUDIO VOLUME VIKING ELECTRONICS HUDSON, WI 54016 2 3 4 5 6 1 2 3 4 SPEAKER OUTPUT PRESS AND HOLD AUTO REPEAT MIC ATTENUATION DEFAULT MSG. 1 5 6 7 LED2 C LED1 PWR STATUS AUX. AUDIO INPUT/ MOH Step 3. Set DIP switch 6 to the ON position for continuously repeated playback. 1ON2 3 4S35 6 7 MAX MIN DIGITAL ANNOUNCER WITH 2 WATT AMPLIFIER RECORD AUDIO INPUT (MIC/ TAPE) START/ STOP Step 2. Connect speakers or auxiliary amplifier. The unit will power up to three 8-ohm speakers, or can provide a 600 ohm signal to auxiliary amplifiers. MAX HANDSET REC/ MONITOR Step 1. Adjust DIP switches 2, 3 and 4 for delay times of 2 seconds - 30 minutes (see Programming section C). MIN MESSAGE REPEAT DELAY TIMES POWER 12V DC Single or multiple informational messages may be repeated continuously or you may use the message repeat delay time option for adding timed intervals between messages. 600 OHM AUDIO OUTPUT 5 REMOTE TRIGGER 4 PWR 3 SPEAKER OUTPUT 600 OHM AUDIO OUTPUT 2 LED2 1 7 MAX MIN DIGITAL ANNOUNCER WITH 2 WATT AMPLIFIER LED1 6 HANDSET REC/ MONITOR 5 MAX RECORD AUDIO INPUT (MIC/ TAPE) 4 MIN START/ STOP 3 REMOTE TRIGGER PRESS AND HOLD AUTO REPEAT MIC ATTENUATION MESSAGE REPEAT DELAY TIMES 2 C LED2 PWR 1 MAX MIN LED1 AUX. AUDIO INPUT/ MOH STATUS RECORD AUDIO INPUT (MIC/ TAPE) 1ON2 3 4S35 6 7 POWER 12V DC VIKING ELECTRONICS HUDSON, WI 54016 DIGITAL ANNOUNCER WITH 2 WATT AMPLIFIER DEFAULT MSG. MAX HANDSET REC/ MONITOR START/ STOP 12V DC Adapter included POWER 12V DC VIKING ELECTRONICS HUDSON, WI 54016 MIN MODEL DVA-2WA MASTER VOLUME AUX. AUDIO VOLUME AUX. AUDIO INPUT/ MOH VIKING © STATUS 120V AC * ON * Note: Up to three 8-ohm speakers may be connected (not included). Viking models 25AE Paging Horn, 30AE Ceiling Speaker or equivalent are recommended. For more information, retrieve Fax Back Document 498. 1 OFF 2 3 4 5 6 7 To input of paging amplifier (not included)