Download Evolution EVO2-50 Specifications

LINKAGE REAR SUSPENSION
To guarantee an optimal operation and the
longest lifetime of the progressive linkage
of the rear suspension, it is recommended
to check after every race/run the correct
tightening of the bolt.
45Nm
4
30Nm
45Nm
To check the upper shock absorber fastening proceed as follow:
Remove screws 1 and 2 (two per side).
Remove the mudguard.
10Nm
2
At the end refit the screws 1 and 2.
Tighten to the torque indicated.
NOTE: It is recommended not to wash with
water jets at high pressure in the zone of
the linkage.
1
10Nm
CHECKS AND MAINTENANCE
Verify that the result of the suspension bolts
to specified torque.
Perform the check according to the times
indicated in the table on page 59.
To verify device, contact authorised Betamotor customer service.
51
GB