Download Daniel Hertz M3 Technical data

Tools commands utility
Set transducer type
Use the pull-down menu to select the appropriate Transducer type and click Write to
reconfigure the meter for this type of transducer.
If any of the changes require a warm start, a message is displayed indicating you should
warm start the meter. Click Yes to warm start the meter to apply the changes.
Important
It is highly recommended not to use this dialog unless a Daniel service representative has instructed
you to do so and has given you specific instructions on what actions to perform.
Click Cancel to close this dialog without making any changes to the meter configuration.
Reset tracking parameters
The Reset tracking menu selection displays the current tracking parameter values for Tspf,
Tspe, and Tamp and allows you to change them if needed.
Click Reset Tracking to write any tracking parameter changes to the meter and reset the
tracking operation in the meter.
108
Daniel 3810 Series Operations Manual