Download Whirlpool Hob Operating instructions
Transcript
PRECAUTIONS AND GENERAL ADVICE CLEANING AND MAINTENANCE • Disconnect the hob from the power supply before Cleaning the hob surface, grates and control panel • • • • • • any cleaning or maintenance operation. The use of a gas appliance produces heat and humidity in the room. Make sure the room is wellventilated, or install an extractor hood with exhaust duct. In case of prolonged use, additional ventilation may be needed (opening a window or increasing the hood extraction speed). Keep children away from the hob when in use and when its has just been switched off. The appliance is not intended for use by people (including children) with limited physical, sensory or mental abilities or without experience and knowledge of it, unless they are under the supervision of or instructed in its use by a person responsible for their safety. After use, make sure the knobs are in the off position , and close the main gas cock or the gas cylinder valve. Attention: The cover (if present) could break if overheated. Before closing it, make sure all the burners are off. • Warning: The protective rubber feet on the grates are a choking hazard for young children. After cleaning the grates, make sure all the rubber feet are correctly fitted. Declaration of Conformity put on the market in conformity with: - safety requirements of “Gas” Directive 90/396/EEC; - safety objectives of “Low Voltage” Directive 2006/95/EC (which replaces 73/23/EEC as amended). - protection requirements of “EMC” Directive 89/336/EEC; - requirements of Directive 93/68/EEC. • This hob is suitable for contact with foodstuffs and complies with (EC) Regulation no. 1935/2004. • This cooking hob (Class 3) has been designed only for cooking food. Any other use (such as heating a room) is improper and dangerous. or lemon juice, etc., on the hob. Stainless steel surface • Clean with a specific product normally available on the market. Note: Continuous use of the hob may alter the colour of the surface near the burners due the high temperature of the flame. Cleaning the burners 1. Lift and remove the cap. 2. Remove the burner by pulling it up. 3. Place the burner and cap in hot water with liquid Note: To avoid damaging the electric ignition, do not use it when the burners are not fitted. different widths. Use pots and pans with bottoms the same width as that of the burners and hotplate, or slightly larger. • Only use flat-bottomed pots and pans. • The pots and pans must not overlap the control panel. • Cook vegetables, potatoes, etc. with a small amount of water in order to reduce cooking time. • Using a pressure-cooker gives a further reduction in energy and cooking time. NO! from 24 to 26 cm from 16 to 22 cm from 8 to 14 cm from 24 to 26 cm from 16 to 35 cm products or steel wool. • Do not use steam cleaning equipment. • Do not use flammable products. • Do not leave acid or alkaline substances such as vinegar, salt detergent. (Do not put in a dishwasher). • If possible, keep the pan covered during cooking. Rapid (9.1 cm) Semi-rapid (6.4 cm) Auxiliary (4.5 cm) WOK (12 cm) Fish kettle (23 cm x 4.5 cm) • Do not use abrasive or corrosive products, chlorine 4. Rinse and dry thoroughly. 5. Make sure none of the burner openings are clogged. 6. Refit the burner and cap. • The hob is equipped with burners and/or hotplate of Pan width supply and wait until it is cool. • Wipe with a cloth moistened with hot water and soap or Clean the hotplate when half-cold. Wipe with a cloth moistened with water and salt, and finish by rubbing with a cloth moistened with oil. diluted liquid detergent. • This cooking hob has been designed, constructed and ENERGY SAVING Burner • Before cleaning the hob, disconnect it from power Cleaning the electric hotplate (if present) TROUBLESHOOTING GUIDE 1. The burner fails to ignite: • Is the gas tap open? • Has the supply of the town gas (methane) been suspended? • Is the gas cylinder (liquefied gas) empty? • Are the burner openings clogged? • Were the flame-spreader and burner correctly positioned after cleaning? (See the section “Cleaning and maintenance”.) 2. The electric ignition does not work: • Is there a power failure? AFTER-SALES SERVICE Before contacting the After-sales Service: 1. Check “Troubleshooting guide” to see if you can eliminate the problem yourself 2. Turn the hob on again to check if correct operation has been restored. 3. If the problem persists, contact the After-sales Service. Give the following information: • type of fault; • hob model; • service number (i.e. the number after the word SERVICE on the dataplate under the hob and on the warranty certificate); • your full address; • your telephone number. If any repairs are required, contact an authorised service centre, indicated in the warranty. In the unlikely event that an operation or repair is carried out by an unauthorised technician, always request certification of the work carried out and insist on the use of original spare parts. Failure to comply with these instructions may compromise the safety and quality of the product. Whirlpool Europe S.r.l. Viale G. Borghi, 27 - 21025 Comerio (VA) Phone 0332.759111 Fax 0332.759268 www.whirlpool.eu