Download Brocade Communications Systems Converged Enhanced Ethernet 8000 Technical data

2
dot1x timeout supp-timeout
dot1x timeout supp-timeout
Sets the time in seconds that a switch waits for a response to an Extensible Authentication Protocol
(EAP) request frame from the client before resending the request.
Synopsis
Operands
Defaults
Command
Modes
Description
Usage
Guidelines
Examples
dot1x timeout supp-timeout seconds
seconds
Specifies the number of seconds that the switch waits for a response to the
EAP frame. The range of valid values is from 1 through 65535.
The default timeout is 30 seconds.
Interface configuration mode
Use this command to specify the EAP response timeout.
None
To set 40 seconds as the switch-to-client retransmission time for the EAP request frame:
switch(conf-if-te-0/1)#dot1x timeout supp-timeout 40
See Also
60
None
Converged Enhanced Ethernet Command Reference
53-1002508-01