Download PV Powered 2500 Technical data

PVI 1800/PVI 2500(Rev A)
Installation and Operation Manual
Fig. 5 PVI 1800/PVI 2500 Mounting Screw Pattern
Mounting Details
Using the mounting diagram Fig. 5, for screw positions on, wall. Four #10 or #12 screws can be used.
It is recommended to use stainless steel screws, especially if used outdoors. Be sure to verify sheer and
pullout strength of anchors or other wall attachments.
NOTE: Always use all 4 mounting screws. It is easiest to layout the 4 screw mounting
pattern using Fig. 5, pre-install the 4 screws, backed out about 1/8-3/16” from the wall
surface, install the inverter, then tighten the screws. The square mounting pattern for the
screws is about 12-5/8” x 12-5/8”. A cardboard template is also included in the box with
the inverter.
13
DOCR-070570-A