Download Digital Audio Corporation MicroDAC IV Technical data

www.asti-usa.com
ASTi DACS: Operation & Maintenance Manual (Version 4, Rev. B.1)
Mechanical Layout AIU
AIU Front Face
Primary Impedance
matching switch
Imp
Hi-Z
Primary
Observer
Mic on/off
DI
DI
DO
Lo-Z
Primary
Headset
AIU Rear Face
Digital Digital Digital
In 1
In 2
Out
Observer
Headset
Obsvr
Mic
ON
Imp
Hi-Z
OFF
Lo-Z
Observer
Obs. Impedance
matching switch
Power
LED
Audio Source
5 VDC
Speaker
Line
Out
Line
In
Input Power
Connector
AIU Bottom Plate
0.15"
7.20 +0.0, -0.01"
2.50"
1.60"
3.10"
0.69"
0.69"
0.15"
Same notch
in all corners
5.28
+/–
0.01"
3.90"
0.69"
0.69"
2.50"
1.60"
The AIU requires 1" of vertical
clearance. The tallest components
are the 1/4" phone jacks.
AIU Enclosure
1.55"
7.5"
5.55"
Note: This product has been obsoleted from the production inventory, but is included here for legacy support. Contact ASTi at 703-471-2104 for information about receiving legacy equipment
documentation.
Copyright © 1999-2006 Advanced Simulation Technology inc.
79