Download DURKOPP ADLER 511 - Operating instructions

Output test
With this testing function, the function of the output elements is
checked.
–
–
Start testing function with the “OK” key.
Select the desired output element by pressing the “ñ” or “ò” keys.
–
Switch the selected output element on and off by pressing the “OK”
key.
==== Output test ====
Output Y1: +
–
Press the function key “ESC” in order to leave the testing function.
Caution – Risk of Injury !
Do not reach into the running machine during the function test of the
output elements.
Outputelement
Function
Y1
Thread clamp/thread wiper (option)
Y2
Magnetic valve for the pneumatic sewing foot lift
Y4
Thread tension
Y13
Thread trimmer magnet
Y18
Separated clamping foot 1, if the option is activated
Y19
Separated clamping foot 2, if the option is activated
Y21
Laser marking light 1, if the option is activated
Y22
Laser marking light 2, if the option is activated
Y23
Laser marking light 3, if the option is activated
Also refer to the “Distributor PCB” section
The current configuration of the outputs is indicated in the sub-menu
“Output assignments” in the “Configuration” menu.
51
1