Download Sharp XG-E3500U Installation guide

Smart Panel Projector Driver Application Note
Sharp XG-E3500U
D. Relays
500mA MAX. CURRENT
1
7B
7A
6B
6A
5B
5A
SELECTION
(EXT. SWITCHER CTRL)
3
2
4B
4
4A
3B
3A
2B
PWR
OFF
MOM.
2A
ON Maintained
ON Momentary
OFF Momentary
Momentary; not Binary
PWR
ON
MOM.
1B
Relay 1
Relay 2
Relay 3
Selection
RELAYS
PWR
ON
MAINT.
1A
The following table specifies the factory preset
settings for the low-current relays found on the rear
of the Smart Panel. The Configuration Utility can
be used to customize these settings your installation.
E. Other Presets
The following table specifies other default factory settings for this Driver that affect is control of the
Projector.
Power Status Feedback Method
Control Wiring Option
RS-232 Polling (see note 1)
Wired Remote (see note 2)
Control for the Sharp with this Driver is via both RS-232 and IR/Wired Remote. We recommend wiring for
the Wired Remote but the included IR emitter may also be used.
The following table specifies settings for the Panel’s configurable timers. For more information on the
inactivity shutdown feature and the lockout timer see the Smart Panel Configuration and Installation
Guide.
Lockout Timer
Inactivity Shutdown
65 seconds (see note 3)
Disabled
© 1999 SP Controls Inc. 601 Minnesota Suite 115 San Francisco, CA 94107
[email protected]