1
Download Motorola RFS6000 - Wireless RF Switch User manual
Transcript
16-4
Motorola RF Switch CLI Reference Guide
16.1.2 deny
MAC Extended ACL Config Commands
Specifies packets to reject
NOTE: Use a decimal value representation of ethertypes to implement
a permit/deny/mark designation for a packet. The command set for
Extended MAC ACLs provide the hexadecimal values for each listed
ethertype. The switch supports all ethertypes. Use the decimal
equivalent of the ethertype listed for any other ethertype.
Supported in the following platforms:
• RFS7000
• RFS6000
Syntax
deny [<MAC/Mask>|any|host <MAC>] [<MAC/Mask>|any|
host <MAC>] {[dot1p|rule-precedence|type|vlan]}
deny [<MAC/Mask>|any|host <MAC>] [<MAC/Mask>|any|
host <MAC>] dot1p <0-7> {rule-precedence|type}
deny [<MAC/Mask>|any|host <MAC>] [<MAC/Mask>|any|
host <MAC>] rule-precedence <1-5000>
deny [<MAC/Mask>|any|host <MAC>] [<MAC/Mask>|any|
host <MAC>] type [8021p|<1-65535>|aarp|appletalk|apr|ip|
ipv6|ipx|rarp|wisp] {rule-precedence <precedence>}
deny [<MAC/Mask>|any|host <MAC>] [<MAC/Mask>|any|
host <MAC>] vlan <1-4094> {rule-precedence|type}
