Download Sherwin-Williams 820-206 Technical data

Transcript
nerd Safe
equlpment%nerates very high fluid pressure. Sprayfrom
thegun,leaksorrupturedcomponents
can inject fluid
through your skin and into your body and cause extremely
serious bodily injury,including the need for amputation. Also,
fluid injectedorsplashed
into the eyes can cause'serious
damage.
%IS
NEVER poim the spray gun at anyone or at any paq of the
body. NEVER put hand or fingers over the spray tip. NEVER
try to "blow back" paint; this is NOT an air spray system.
ALWAYS have the tip guard in place.on thespray gun when
spraying.
ALWAYS follow the Pressure Relief Procedure, below,
beforecleaning or removing the spray tip orservicingany
system equipment.
N N E R try to stop or deflect leaks with your hand or body.
Be sureaquipmentsafetydevicesareoperatingproperly
ra G n 8af
B
sJe JI gun s % * E 2 Z a r e
operating prop& before
each use. Do not remove or modifv anv Dan of the wn: this
can cause a malfunction and result'in &Nous bodilykju.ry.
Safety Latch
'Whenever you stop spraying, even for a moment, always set
the gun safety latch in the closed or "safe" position. making
the gun inoperative. Failureto set the safety latch can resultin
accidental triggering of the gun.
Diffuser'
T e gun diffuser breaks up spray and reduces
the risk of injechon when the tip is not installed. Check diffuser operation
regularly.Followthe
Pressure Relief Procedure, below,
then remove the spray tip. Aim the gun into a metalpail,
holding the gun firmly to the pail. Using the lowest possible
pmsure. trigger the gun. If the fluid emittedis not diffused into an irregular stream, replace the diffuser immediately.
np
i Guard.
ALWAYS have the tip guard in place~onthe spray gun while
spraying. The tip guard alerts you to the injection hazard and
helps prevent accidentally placing your fingers or anypan of
your body dose to the spray tip.
before each use.
edi!
I rmtmetnt
?
anyT Bamears to Denetrate vour skin. aet
UI
a
Ti
Safe81
e&&
cautio when cleaning or changing spray tips. If
the spray tip clogs while spraying, engage thegun safety latch
immediately.ALWAYS follow the Pressure Relief Procedure and then remove the spray tip to clean it.
NEVER wipe off build-up around the spraytip until pressure is
fully relieved and the gun
latch is engaged.
sa+ty
e thegun safetylatch. (51 Hold
prensura. (61 Engage the gun
If
YOU suspect that thespray tip or hose is completely dogged, or that pressure has not been fully relievedafter following the
Steps above. VERY SLOWLY loosenthe tip guard retainingnut or hose end coupling and relieve pressure gradually,
then loosen
completely. N o w dear the tip or hose.
pi
ENGAGESAFETY
TURN SWITCH TO OFF
UMPLUG CORD
DISENGAGE SAFEW
AND TRIGGER GUN;
ENGAGE SAFEW A G A I ~ ~
OPEN DRAIN VALVE
.
.