Download Avanti Model Specifications
Transcript
11.3 Assembly in tower factory 11.3.1 Top tower section 4. Install the top mechanical stops and the top limit plate (see Fig. 4 and installation drawing). Use 15 N·m torque for M8 and 50 N·m for M12. 1. Install and adjust upper ladder section at the top of the top tower section (see Fig. 1 and installation drawing). Use 15 N·m torque for M8 and 50 N·m for M12. Fig. 4 11.3.2 Intermediate tower sections 1. Install and adjust upper ladder section at the top of the intermediate tower section (see Fig. 1 and installation drawing). Fig. 1 2. Install the rest of the ladder sections from top to bottom (see Fig. 2). 2. Install the rest of the ladder sections from top to bottom (see Fig. 2). 3. Install the rest platforms approximately every 9 m (see Fig. 3 and installation drawing). 4. Install the electric cable arm support (see Fig. 5 and installation drawing). Fig. 2 Fig. 5 3. Install the rest platforms approximately every 9 m (see Fig. 3 and installation drawing). 5. (If platform switch 1) on service lift is provided) install a safe zone plate on the ladder at each platform. 11.3.3 Bottom tower section 1. Install and adjust upper ladder section at the top of the bottom tower section (see Fig. 1 and installation drawing). Optional for CE bucket type version. Mandatory for CE full sliding door version. Optional for AECO version. 1) Fig. 3 User’s, Installation and Maintenance Manual 37