Download Show Designer 2D

Transcript
OVERVIEW
The Show Designer 2D is a lighting controller based on the successful and simple to use Show Designer.
The Show Designer 2D expands on the existing features and adds several others. The approach of this
controller is to try to simplify the programming process as much as possible while still offering a high
level of control at a low cost.
48 lighting fixtures of up to 32 channels each can be controlled using 2 DMX 512 outputs. Control of up
to 1024 DMX channels is possible. Support of Elation and Robe lighting fixtures as well as other popular
brands is included in the setup menu. Lighting fixture profiles can also be downloaded from the Elation
web site.
The operating system uses flash memory so that the software can be updated from a computer or the
floppy disk drive. Software updates will be made available on the Elation Lighting web site at
www.elationprofessional.com .
REAR PANEL
• Power input for an external 9V power supply. This requires a transformer with a 9VDC output at
1200ma. The plug polarity is + center with an inside diameter of 2.1 mm.
•
2 DMX 512 outputs each with a 3 pin and a 5 pin XLR connector. There is a polarity switch for the 3
pin XLR which swaps pins 2 and 3. Some lighting fixtures send data minus on pin 2 and some on pin
3. The more commonly used polarity is data minus on pin 2 (switch is to the right as you’re looking at
the back of the unit).
•
MIDI in and out - used for calling scenes in an automated installation.
•
9 pin RS-232 connector - used for connection to a PC to update the software or backup the memory
in units that don’t have the disk drive installed.
•
Keyboard – used to attach a PS2 keyboard for data entry.
•
Audio input - used for syncing chases to an external audio source. This is a line level input for
connection to the line output of a mixing console. Do not connect speaker level signals to this.
•
Disk Drive - This you to back up the memory, input lighting fixture profiles or update the software
using standard 3.5” 1.44 MB floppy disks.
FRONT PANEL
Front panel features include assorted switches for programming, eight 60mm faders for direct control of
lighting fixture channels as well as for scene masters, 4 wheels for channel control and data entry, a
joystick for pan and tilt control and a backlit display for programming. There is also a 3 pin XLR
connector for a work light.
1