Download Dimplex DC700 User manual

INSTALLATION AND USE MANUAL
IMPORTANT!
Air flow may also be obtained from a room adjacent
to the installation room as long as this flow is free
through
permanent
apertures
that
directly
communicate with the outdoors; avoid air outlets
connecting with heating units, garages, kitchens or
bathrooms.
2.4.
CHIMNEY FLUE PREPARATION
The connection to the chimney flue is a very important element. Before
installing, check the chimney flue is in good condition; dry and free
from cracks and obstructions. The diameter of the chimney flue should
not be less than 180mm and not more than 220mm in diameter. If any
of these requirements are not met, the chimney should be lined by a
suitable method by a qualified person.
The chimney height and the position of the chimney terminal should
conform to Building Regulations. If you have any doubts about the
suitability if your chimney, consult your local dealer or stockist.
The chimney must be swept before connection to the stove and should
be swept yearly thereafter.
Do not install this appliance on a shared flue.
2.5.
CHIMNEY FLUE PIPE
The chimney flue pipe is a fundamental element in discharging
smoke and therefore must have the following requisites:
•
It must be waterproof and thermally insulated.
•
It must be made with heat resistant materials, resistant to
combustion products and any condensation.
•
It must have a vertical slope where possible with axis
deviations not over 45° and without narrowing.
•
It must meet the requisites indicated in the technical table for
the internal chimney section and height.
•
It must preferably have a circular interior section.
•
It must be cleaned before installation and at least once yearly
thereafter.
The flue pipe is of primary importance for the correct
functioning and safety of your fireplace stove.
2.5.1. Examples of chimney flue pipes
Technical service – Dimplex - all rights reserved - Reproduction prohibited
Chapter 2
page
10