Download Yamaha CRW4260t-B Technical information

Pro Tools LE Audio File Storage Requirements for Mac OS
IDE/ATA: Full 24 track, 24 bit, 48 KHz performance from just one dedicated IDE/ATA audio
drive is supported on qualified G3 and G4 Pro Tools LE systems*
SCSI: Using a dedicated SCSI drive and SCSI HBA (Host Bus Adapter) card will, in general,
provide the same performance as an IDE/ATA drive, with the exception that IDE/ATA drives may
take a couple seconds to start recording 24 tracks. External SCSI drives should be used if you
desire portability.
Firewire Hard Drives
The DigiDrive FireWire 80 has been qualified with Pro Tools LE systems for the following:
●
Supported track count: 24 tracks on one drive at 48 KHz/24-bit @ 500ms edit density
For more information and specific requirements, see DigiDrive FireWire 80 Requirements
Requirements for both IDE/ATA or SCSI drives:
●
Minimum speed of 7200 RPM & average seek time of less than 10.0 ms
●
For 24 tracks, drives must be dedicated for audio (internal or external)
●
Boot drives may be used for audio tracks, however performance/track count may vary
●
●
Mac OS file system: HFS or HFS+. SCSI drives should be initialized with ATTO
ExpressPro-Tools v2.3.2 or higher, IDE/ATA drives should be initialized with Apple's
Drive Setup.
Note: Mac OS 9.2 requires ATTO ExpressPro-Tools v2.7 or higher, available from
www.attotech.com/software
●
●
ATTO ExpressPro-Tools settings: Synch Transfer Rate set to 20 (10) and PCI Burst Rate
set to 32 bytes
If using non-ATTO ExpressPro-Tools initialized drives, click here for options.
For supported SCSI HBA cards check the compatibility document of your specific
computer model.
*IDE/ATA support is limited to Powermac G3 or later models, which include a built-in ATA bus.
Pre-G3 models that only shipped with SCSI have not been tested with add-on ATA/IDE controller
cards.
Digidesign Compatibility Documents Index