Download Sharp SD-PX2 User`s manual
Transcript
Configuration and Operation Chapter 2 Configuration and Operation 2.1 Introduction This section contains configuration information, connection descriptions, and other operational information that may be useful during the development process. 2.2 Configuring Board Components Table 2-1 is a summary of configuration settings. The following paragraphs provide additional information about configuring and using the ADS. Table 2-1. Component Configuration Settings Component Position Effect System Power Switch, SW1 SW1 OFF ON Move this switch to the ON position to enable the power source connected to P8 to power the system. Factory setting is OFF. BOARD EDGE System Reset Switch, SW2 Push to reset the M9328MX21ADSE. SW2 S1 ON 1 2 3 4 5 6 7 8 Peripheral Selection Switch, S1 The UART1 and UART4 transceivers are forced enabled, the IrDA module is enabled by software, Nexus is disabled, ARM mode JTAG is selected, and the buzzer is connected to PWMO. The LCD touch panel signals are connected. Factory setting is shown. Subsection 2.2.1 explains other settings for this switch. S1 Mode Switch, S2 S2 ON 1 2 3 4 5 6 7 8 Configures 32-bit Burst Flash as the boot device and the Default clock bypass mode is selected. Factory setting is shown Subsection 2.2.2 explains other settings for this switch. S2 Power Headers (on CPU card) J1, VCC (3.0 V) J2, 1.8 V J3, 1.5 V 1 2 Connects specified power signal. Factory Setting (Leave jumper installed during normal use.) 1 2 Connect ammeter across pins to measure processor current consumption from the specified power source. M9328MX21ADSE User’s Manual, Rev. A Freescale Semiconductor 2-1