Download Multitech MultiModem Cell MTCBA-C1 User guide
Transcript
Chapter 13 – OMA / DM Control Commands Examples: Example 1: Example 2: Client-initiated device configuration request, no errors AT+WDSS=1,1 OK +WDSI: 4 +WDSI: 6 +WDSI: 8 Client-initiated device configuration request, authentication error AT+WDSS=1,1 OK +WDSI: 4 +WDSI: 5 Wavecom Device Services Configuration +WDSC Description: This Wavecom proprietary command allows a user to configure: • The user agreement for connection, package download and package install • The mode of automatic registration to the IDS server Syntax: Command syntax: AT+WDSS=<Mode>,[<State> || <Config>] Command Possible Responses <Mode>= 0, 1, 2, 3 OK AT+WDSC=<Mode>,<State> <Mode>= 5 Note: No connection to the server and the used PDP context AT+WDSC=<Mode>,<Config> for the next connection is the one defined by the provisioning. AT+WDSC? +WDSC: 0,<State> +WDSC: 1,<State> +WDSC: 2,<State> +WDSC: 5,<Config> OK AT+WDSC=? +WDSC: (list of supported<Mode>s), (list of supported [<State>s ]<Config>] OK Values: <Mode> 0 1 2 3 4 5 <State> 0 1 <Config> 0 1 Parameter Storage: User agreement for connection When this mode is activated and when a notification SMS is received by the modem, an indication (see +WDSI indication) is returned by the modem to request an agreement before connecting to the IDS server. User agreement for package download When this mode is activated, an indication (see +WDSI indication) is returned by the modem to request an agreement before downloading any package. User agreement for package install When this mode is activated, an indication (see +WDSI indication) is returned by the modem to request an agreement before installing any package. Not Supported Not Supported Registration configuration The registration is performed using +WDSS command. Status of the mode (Only for <Mode>= 0, 1, 2) Disabled (default value) Enabled Status of the Registration configuration (Only for <Mode>= 5) Not configured (default value) Configured <State> and <Config> parameters are stored in flash without using &W command. &F has no effect on these parameters. Multi-Tech Systems, Inc. CDMA C1 AT Commands Reference Guide (PN S000478C) 69