Download UPRIGHT FREEZER

Using your freezer
Setting
the cold control..
.
To Start, turn control to the middle
of the dial.
This setting is designed
to maintain
temperature
at or near 0 F [ 17.8 C) under normal operating
conditions.
I
Adjus ting cold control..
l
l
.
Turn ‘::ontrol
to higher
number
for colder
tempt hratures.
Turn tc lower number for less cold temperatures.
Coolilrlg freezer first.. .
Allow freezer to cool 6 to 8 hours before
with frmazen food.
before
adding
0 Let it ~cool overnight
amoul it of unfrozen food.
l
filling
large
Note: W,ien freezer is first started the compressor
will run constantly
until the cabinet
is cooled.
It
may tab e up to 6 to 8 hours or longer, depending
on roonj temperature
and the number of times
the free. er door is opened.
After t le cabinet is cooled the compressor
will
turn on clnd off as needed
to keep freezer at
proper iemperature.
Temperature
Alarm
The Temperalure
Alarm (located
on the right
side of the base grille) works together
with an
electronic
Temperature
Sensor (located
inside
the freezer - sensing freezer air temperature)
to
alert the user to an abnormal
condition
which
has caused
freezer air temperature
to rise to a
level which may be unsafe for frozen food storage. It is designed
to sound a continuous
tone if
the freezer becomes
warm.
freezer temperature
may become
too warm
if...
l The door
is not tightly closed.
. The door has been opened too many times, or
has been left open too long.
l The Cold
Control is not set correctly.
l A large
food load has been added.
l The freezer
IS disconnected.
. There has been a power failure, or a circuitbreaker
is tripped
or a fuse blown.
Wher the Temperature
Alarm
iwitch
in ON, the
ON
Temper lture Sensor in the
freezer senses freezer air
temper
lture. If the temperature
becomes
too
warm, t?e Temperature
Alarm is designed
to
sound c continuous
tone.
You w II hear a different
sound if the battery is
about tc’wear out.The alarm is designed
to beep
(chirp) c>very 30 to 60 seconds to indicate
a failing batery.
If the :+mperature
Alarm
sounds I continuous
tone
OFF l[I1I1
and
tl,e
Temperature
I3
Alarm s.vitch is ON, move
the switl h to OFF.
Make jure you know why the freezer became
tooworr~i.lftheproblemisserious(powerfailure)
and ser .,ice or assistance
is needed,
see page
11. If the problem
is simple (door open, freezer
unplug<;ed)
correct it. Move the switch back to
ON whe ‘1the freezer is cold again.
The b:?eping
that indicates
a failing battery
cannot
:)e stopped
by moving the Temperature
Alarm Stiitch to OFF. It can be stopped
only by
removir g the battery Replace
immediately
with
a 9-volt alkaline
battery.
Checl
the battery often
by moving
the Temperamm
ture Alclrm Switch to the
I3
TEST pc sition. The alarm
TEST
should s:)und a continuous
tone, re!jardless
of freezer
air teml.‘erature.
If the alarm doesn’t sound a
tone wit.1 the switch in the TEST position, replace
the butt< ‘ry immediately.
5